PosiClean® and FlatClean FC12™ belt assembly – ERO Joint® lacing

The installation method is the same as belts with textile ply
 

Step 1

Posiclean® belt applying solutionTo start the assembly:
Need to apply some solution in every hole of each finger on one side of the belt. (This solution can be used as a lubricant and therefore make the assembly easier).

 

 

 

Step 2

Posiclean® belt fingers alignedThen fit quickly the fingers of joint together. (The lubricant is not drying).

 

 

 

 

Step 3

Posiclean® belt rods insertionFinally, insert the rods in the hole by taking care that the rods stay in the hole and not under the belt, outside fingers.

(It is recommended to use a plank on the belt to keep it and a clamp to push the rod). If the threading of a rod is too difficult, it can be cut to make the thread by the other side of the belt or in the middle of the belt.

 

 

Step 4

Posiclean® belt assembledPlease ensure that the rods do not exceed to avoid they cling.

 

 

Wipe up any drips of lubricant.
This lubricant is not a dangerous or toxic substance, it is conform to FDA standards.

 

The belt can be tensioned (like a welded belt), adjusted and the conveyor can start-up.

The implementation solution is a lubricant that will solidify and paste over time.
The solution makes the assembly easier and avoid any migration of the rods outside the operating belt.